The focus of this webinar is on major changes to the standard and their implementation in EasyPower. Following publication, this second edition of the widely adopted industry standard includes an entirely new arc flash model with revised procedures and calculations to predict arc flash hazard levels. This webinar, given by Greg Pagello at EasyPower, is an introduction to changes in the new IEEE 1584-2018 Guide for Performing Arc Flash Hazard Calculations recently, approved by the IEEE Standards Association. NFPA 70E 2018: Table 130.7 (C)(15)(a) Arc-Flash PPE Categories for Alternating Current (AC) Systems Equipment Arc-Flash PPE Category Arc-Flash Boundary Panelboards or other equipment rated 240 volts and below Parameters: Maximum of 25 kA available fault current maximum of 0. Webinar Video - IEEE 1584-2018 Update – An Introduction to the Changes EasyPower information page on IEEE 1584-2018 update.Get the latest arc flash hazard resources from EasyPower, IEEE, and NFPA : Try a free demo copy today and experience the fastest, easiest to use arc flash analysis on the market. You can also contact us if you have questions, to get a quote, or would like to schedule a one-on-one session with an application engineer, to help understand how EasyPower can be an integral part of your arc flash safety program.ĭownload Demo Request a Quote Stay Up-to-Date By clicking on the Calculate Arc Flash button, you agree to waive all claims against EasyPower LLC, or it's employees, and release them from all liability arising from use of the calculator. Typical working distances can be found in the Table below based on the class of. Arc-flash design protection is normally based the incident energy level of the working person’s head and torso at the working distance. Typical Working Distances For Arc-Flash Calculations per. Used to calculate arc flash values for personal protection. Electrical and Electronics Design and Engineering. This is outlined by NFPA 70E - 2004, Electrical Safety Requirements for Employee Workplaces, states, A hazard analysis shall be done in order to protect personnel. This explosive energy is measured in calories/cm2. * NOTE: This is a demonstration tool only and is not meant to be NFPA 70e calculations are necessary to properly determine the explosive arc flash energy level of a worker who could be exposed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |